Newer
Older
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
;
; Asterisk Call Detail Record engine configuration
;
; CDR is Call Detail Record, which provides logging services via a variety of
; pluggable backend modules. Detailed call information can be recorded to
; databases, files, etc. Useful for billing, fraud prevention, compliance with
; Sarbanes-Oxley aka The Enron Act, QOS evaluations, and more.
;
[general]
; Define whether or not to use CDR logging. Setting this to "no" will override
; any loading of backend CDR modules. Default is "yes".
;enable=yes
; Define the CDR batch mode, where instead of posting the CDR at the end of
; every call, the data will be stored in a buffer to help alleviate load on the
; asterisk server. Default is "no".
;
; WARNING WARNING WARNING
; Use of batch mode may result in data loss after unsafe asterisk termination
; ie. software crash, power failure, kill -9, etc.
; WARNING WARNING WARNING
;
;batch=no
; Define the maximum number of CDRs to accumulate in the buffer before posting
; them to the backend engines. 'batch' must be set to 'yes'. Default is 100.
;size=100
; Define the maximum time to accumulate CDRs in the buffer before posting them
; to the backend engines. If this time limit is reached, then it will post the
; records, regardless of the value defined for 'size'. 'batch' must be set to
; 'yes'. Note that time is in seconds. Default is 300 (5 minutes).
;time=300
; The CDR engine uses the internal asterisk scheduler to determine when to post
; records. Posting can either occure inside the scheduler thread, or a new
; thread can be spawned for the submission of every batch. For small batches,
; it might be acceptable to just use the scheduler thread, so set this to "yes".
; For large batches, say anything over size=10, a new thread is recommended, so
; set this to "no". Default is "no".
;scheduleronly=no
; When shutting down asterisk, you can block until the CDRs are submitted. If
; you don't, then data will likely be lost. You can always check the size of
; the CDR batch buffer with the CLI "cdr status" command. To enable blocking on
; submission of CDR data during asterisk shutdown, set this to "yes". Default
; is "yes".
;safeshutdown=yes
; Normally, CDR's are not closed out until after all extensions are finished
; executing. By enabling this option, the CDR will be ended before executing
; the "h" extension so that CDR values such as "end" and "billsec" may be
; retrieved inside of of this extension.
;endbeforehexten=no
;[csv]
;usegmtime=yes ;log date/time in GMT
;loguniqueid=yes ;log uniqueid
;loguserfield=yes ;log user field